DAVIKA FTR-01-DQD flip mount for EOTech G23, G30, G33, G43, G45 magnifiers and magnifiers with the EOTech footprint. It installs on the rear DQD interface of RDM red dot mounts and puts the magnifier on the 57 mm (2.25″) optical axis, in line with the sight.
The mount installs on DQD without tools: the lever locks it in the working position and releases it, with no loss of zero. Thanks to the DQD interface the design is lighter and has a more compact, streamlined profile than a Picatinny magnifier mount: the manufacturer lists 58–74 g for DQD versions versus 115–131 g for PIC-QD. That matters because a magnifier can weigh several times as much as a red dot (EOTech G45 269.3 g, Aimpoint Micro T-2 94 g per the makers), so it is convenient to carry it separately and attach it when magnified target identification is needed.
The flip-to-right mechanism moves the magnifier off the optical axis in one motion, rotating about 90°. Unlike common designs where spring-loaded balls hold the magnifier only at the two end positions, in the FTR a spring presses on the flip arm through a bronze slide over the full travel: the magnifier holds in any position, and there is no play in the working position. The tension is asymmetric, harder to flip out than to return, so contact with gear does not knock the magnifier off axis, and the working position can be felt by hand.
DQD versions accept an optional magnifier shield: when flipped, the lens ends up next to the ejection port, and the shield fully covers it against powder gases, impacts and during storage.
The manufacturer advises zeroing the red dot without the magnifier and checking it with the magnifier. The mount provides mechanical compatibility and a common optical axis; whether a given sight and magnifier pair works together depends on the devices themselves. If the magnifier already has a 36 or 40 mm mount, a PR-03-DQD rail can raise it to 57 mm.
The mount is built for hard use on AR-15, AR-10 and SR-25 rifles: 7075-T6 aluminum, MIL-A-8625 Type III hard anodizing, stainless-steel screws.
The mount has a finish of black hard anodizing: the matte surface does not glare and matches rifles with black furniture.
Key Advantages
- Flips about 90° to the right in one motion
- Held over the full travel through a bronze slide, no play in the working position
- Asymmetric tension: harder to flip out than to return
- Tactile indexing of the working position
- 57 mm (2.25″) optical axis shared with RDM mounts
- Tool-free installation on DQD, DQD versions weigh 58–74 g
- Optional lens shield in the flipped position
Technical Specifications
| Parameter | Value |
|---|---|
| Model | FTR-01-DQD |
| Magnifier compatibility | EOTech G23, G30, G33, G43, G45; Trijicon 3X; Vortex VMX-3T, MICRO3X, MICRO6X |
| Color | Black |
| Mounting base | Dovetail QD interface of RDM mounts |
| Optical axis height | 57 mm (2.25″) |
| Flip direction | To the right, about 90° |
| Weight | 58–74 g (DQD versions) |
| Platforms | AR-15, AR-10, SR-25 |
| Material | 7075-T6 aluminum |
| Coating | MIL-A-8625 Type III hard anodized |
| Country of manufacture | Ukraine (Kharkiv) |
Applications
A red dot and magnifier setup on AR-15, AR-10 and SR-25 rifles: fast switching between close range and magnified target identification, including with a thermal clip-on.